Stealth Question

[hongkongguy]

How To Prevent Puncture A Hole Of The Sachet When Drawing? How Do You Get Every Drop From The Bottom Without Breaking It?

[jstforme]

you might want to cut a corner off so you can see better

[shawn burnham]

How To Prevent Puncture A Hole Of The Sachet When Drawing? How Do You Get Every Drop From The Bottom Without Breaking It?

Put the Stealth packet in a small, sterile coffee cup. If the cup is the right size, it will hold the sachet in place for you. Place the sachet "corner up." Cut just enough off the corner so you have a small openning for your needle. Put your needle in gently about an inch. Suck out as much gear as you can, 1 or 2ml. Cut the sachet again half an inch lower. Now you have a big openning and you can see exactly what your doing. The cup will continue to hold the sachet in position for you. Since the cup is fresh from the dishwasher and sterile, if you spill any gear, you can just suck it out of the bottom of the cup.

This is how i do it everytime. Works great.

[Cracker]

Put the Stealth packet in a small, sterile coffee cup. If the cup is the right size, it will hold the sachet in place for you. Place the sachet "corner up." Cut just enough off the corner so you have a small openning for your needle. Put your needle in gently about an inch. Suck out as much gear as you can, 1 or 2ml. Cut the sachet again half an inch lower. Now you have a big openning and you can see exactly what your doing. The cup will continue to hold the sachet in position for you. Since the cup is fresh from the dishwasher and sterile, if you spill any gear, you can just suck it out of the bottom of the cup.

This is how i do it everytime. Works great.

sounds like a good idea, i was sittin here earlier gettin gear all over my hands,,,,ha,,,, hey I was still able to get 5 and a half ml from each packet. Fuck it.

[chestmaster1]

How To Prevent Puncture A Hole Of The Sachet When Drawing? How Do You Get Every Drop From The Bottom Without Breaking It?

You an 18g with a 10cc, sucks it all right up

[Tyrone]

Bump jstforme, Cracker, and chesmaster...Just cut the shit at the top and draw it up...

[Fredddd]

cutting up the sachets with non sterile scissors is not a very good idea.A sterile coffee cup? Hold the sachet with one hand, swap with alcool one side of the corner, introduce slowly the needle and suck it up. I pull out 6 ml every time i use this process very slowly and carefull. Be patient

[SwoleTexasKid]

Actually the best way to do it is by pulling the plunger off the back of the syringe, and pouring the oil directly in.

I did this with great sucsess and it saved a lot of time.

[C-man]

Bump Freddd!

thats how I do it too

[brickhouse1]

That sounds like a good idea. I just spent about a half hour putting 45ml's into a 50cc bottle. that way sounds way more efficient. Thanks Brick