IP bulk steralization

[anaholic]

For those of you who have used IP bulk, has anyone every gotton an abcess from it ? and if so was it both steralized and filtered before use?

[sTaTic]

not here bro... all good with just whatman filter

[anaholic]

if nobody has ever gotton an abcess how do we know IP bulk really needs to be filtered and steralized ?

[sTaTic]

alin says that it should be transfered at least. you be the judge. I think people are just doing it for there own sake. Mind thing I guess :confused:

[Tyree33]

My first couple exp. w/ ip bulk products I didn't even filter them and I had great results and no sides. But now days I always make sure to at least filter through a whatman just to be on the safe side, you can never be too safe when it comes to your health.

[iridiumblue]

For those of you who have used IP bulk, has anyone every gotton an abcess from it ? and if so was it both steralized and filtered before use?

Abcesses usually come from injecting too many times in the exact same spot. You get an oil build up from it. Reactions from high BA levels or other contaminants usually shows up in form of redness, swelling and fevered area.

[Alin]

not here bro... all good with just whatman filter


sterile vial and whatman filter is all you need to ensure clean product.

[riverat42000]

if nobody has ever gotton an abcess how do we know IP bulk really needs to be filtered and steralized ?
UUUUUUUHHHHHHH.....because we all filter it.........would you want to take the chance......not me. best to follow the directions and not take the chance.. :confused:

[mickeymbbc]

Yes,....filter It??



-mick

[zozom]

I can t understand how it can be possible to put the sealed sterile vial in a oven at around 250c without that the flips top melt?

I don t know how look like a sealed vial.... however

[Gregalmighty]

ZOZOM, its 250 degrees farenheit and you need a pin in the stopper to vent the heated air escaping the vial. 250 is just enough to bubble the oil, in farenheit 212 degrees boils water. The stopper will not melt. hope this explains your question.

[boomer]

where's best place to get whatman filters? gpz service's website isn't working right now.

[zozom]

A video would be nice to see, i would not risk to melt the stopper and throw my juice because there is plastic melted in my juice.

[zozom]

A video would be nice to see, i would not risk to melt the stopper and throw my juice because there is plastic melted in my juice.

you need a pin in the stopper to vent the heated air escaping the vial.

What size for the pin? 18G is enough?

[zozom]

A video would be nice to see, i would not risk to melt the stopper and throw my juice because there is plastic melted in my juice.

you need a pin in the stopper to vent the heated air escaping the vial.

What size for the pin?

what is a pin it is a needle? if it is not where can i buy a pin?

[anaholic]

needle and pin is same thing, the rubber stoper wouldnt melt it would just get hard and cracked if anything,

[zozom]

Do somebody can tell me what is the gauge to use in the stopper to vent the heated vial?

[sowrdiezel]

best bet is to go for an 18g but if you really dont want to take a chance of chewing up the stopper try a 20g

[zozom]

ok thx you i am almost ready to sterilize

[sowrdiezel]

no doubt anytime

[jvoutlaw]

.................................................. .............