Quick Stealth Question

[mm70]

When removing from the corner of the packet, do you cut the corner with scissors or just peirce the packet with the surringe?

[opusx]

I cut the corner. I start with a small cut, after I have filled one or two syringes I make the cut larger so I can open the packet and see in there better.

[mm70]

What do you use to cut the packet? How do you sterilize??

[opusx]

i don't sterilize, there is no need. and I use scissors to cut

[hismadnessty]

The contents is sterile, and the brief air-exposure isn't going to hurt you.

[sTaTic]

I probably should have cut but I just pierced it. all fine here ;)

[Tyrone]

I probably should have cut but I just pierced it. all fine here ;)
Did you happen to change needles after?

[Alin]

Use scissors and cut small section of corner satchet.

[jverch]

I've had fine luck just piercing with pin, but do what work best for ya

[1scuba]

I have a pair of scissors that I only use for the packets and I wipe them with alcohol before use.

[bob loblaw]

I have a pair of scissors that I only use for the packets and I wipe them with alcohol before use.
That is a good practice.

[sTaTic]

Did you happen to change needles after?


If you mean did i use the same needle to inject, then no, I changes needles. I just used one pin to pearce and inject into a vial. the whole syringe and pin was tossed after

[Tyrone]

If you mean did i use the same needle to inject, then no, I changes needles. I just used one pin to pearce and inject into a vial. the whole syringe and pin was tossed after
Cool, that's how I'm about to do it.