Sterilizing Gear

[sszapdog]

what if you botch up transfering stealh to a bottle? ie drooling into the pouch while pulling up on the syrindge with your teeth because you just dont have three hands. how`s this-heat a vial with suspect gear with 18g pin through the top in oven for what 10 -20 min. what happens to the rubber in the stopper with a hot needle in it? what oven temp is good? or do you just pitch the gear? can it be done or is it dumbass?

[tatteredxangelx]

you worry too much ... if you're that concerned run it through a whatman filter into a new sterile vial.

[medivac_driver]

dude the only way to properly sterilize oil is to heat it to 175 degrees for at least 4-5min, i'm sure the rubber stoppers where not originally sterilized with heat but ethyl oxide due to the fact that they would melt.

not sure what a whatman filter is, but if it a filter needle i'm not sure how small it will filter down to, an it might be a bitch to draw oil through. good luck

[Rhandhular]

you worry too much ... if you're that concerned run it through a whatman filter into a new sterile vial.
This is solid advice.

[Alin]

You could heat oil in a vial with no stopper, 250 degrees for 20 min, let cool, then run thru whatman filter into sterile vial.

[sszapdog]

solid reply.