VTliftVT
06-03-2008, 07:22 AM
So I was reconstituting my GH not too long ago and used a 23g 1'' needle to put the BA water into the vial. Well I had to inject that day as well and since I have amps of test e, I always start off with the deca 1st since its in a vial.
Well I accidently had a couple of drops of my BA water (from the GH reconst) drop into the deca as I was using the same needle to draw with but was going to switch to a different for the injection. Well that initially started off as a couple of water bubbles and settled on the bottom but now its made the gear a little cloudy. I am not concerned with any contamination as I have used it the past couple weeks with no problem. My question is will it affect the deca negatively in its activeness (ie affect its chemical composition)?
Also, I have heard some say mixing the compounds and shooting at once will limit the amt of effectiveness each has? I wouldnt think so but is there any truth behind that?
Thanks!
VT
Well I accidently had a couple of drops of my BA water (from the GH reconst) drop into the deca as I was using the same needle to draw with but was going to switch to a different for the injection. Well that initially started off as a couple of water bubbles and settled on the bottom but now its made the gear a little cloudy. I am not concerned with any contamination as I have used it the past couple weeks with no problem. My question is will it affect the deca negatively in its activeness (ie affect its chemical composition)?
Also, I have heard some say mixing the compounds and shooting at once will limit the amt of effectiveness each has? I wouldnt think so but is there any truth behind that?
Thanks!
VT